JBL Audio Connections, SDEC-30007.1, Surround Processor to SDEC3000 Inputs, S3000IC, Number

4 SDEC Hardware Connection

Please refer to the SDEC Installers Manual for detailed hardware connection instructions and diagrams. Check the SDEC for correct connection using the below chart for SDEC-3000 and the next page for SDEC-4000 installations:

•Make sure you have access to the SDEC-3000 or SDEC-4000P and SDEC-4000X Ethernet port(s).

•Make sure you are using the correct interconnect kit, S3000IC or S4000IC.

•The system should pass audio and all channels should operate before beginning the calibration.

•The SDEC-4000P and SDEC-4000X need to be connected to each other via the Cobranet® connection using a CAT5e crossover network cable and must be a minimum of two feet (0.7 meter) long.

4.1 Audio Connections

SDEC-3000 7.1

Surround Processor to SDEC3000 Inputs

S3000IC		SDEC3000
Number	Channel	Inputs
1	Left Front	A1
2	Right Front	A2
3	Center Front	A3
4	Left Side	A4
5	Right Side	B1
6	Left Rear	B2
7	Right Rear	B3
	Subwoofer
8	(Mono Sub LEFT)	B4
SDEC3000 Outputs to Amplifiers
S3000IC		SDEC3000
Number	Channel	Outputs
9	Left Front	C1
10	Right Front	C2
11	Center Front	C3
12	Left Side	C4
13	Right Side	D1
14	Left Rear	D2
15	Right Rear	D3
16	Subwoofer	D4

Figure 1.

- 6 -

SDEC -X000 DACS Calibration Manual v1.0.doc