6 Software Operation using London Architect™
NOTE: While it is possible to use a WIFI access point to control and configure the SDEC we do not recommend using this method for initial setup when using London Architect. For the most reliable connection it is highly recommended that you use a wired connection.
6.1 London Architect™ Software Setup
If this is the first time you are using the London Architect™ Software you will need to open the IP properties and make sure your computer is ready to connect to the SDEC.
Open the London Architect software from your Start menu All Programs. Go to Tools Application Preferences HiQnet. Use Passive FTP should be checked and the correct Network Interface Card should be checked. All other settings should be left at the default
Figure 6.
6.1.1Network Control Panel
Open London Architect first. Make sure you are connected to the same network and subnet as the SDEC. You should see the unit(s) appear under the Network control panel listed within the Ethernet node. If you cannot see the Network control panel go to View Network. If you cannot see the unit(s) you should first check all network settings and connections. Please check the troubleshooting section for more details.
View this Network panel to see the attached devices.
Figure 7.
6.2 Initial Software Connection to the
SDEC
If you are using
•Firmware
•HiQnet Address
•Design configuration
•Parameter synchronization
NOTE: If the Firmware or HiQnet address needs to be updated the unit will need to be rebooted and the software will not be able to automatically connect. In this case you will need to manually select ONLINE. Please see the diagram below for instructions.
Click here to manually select “ONLINE” mode and begin controlling the
Figure 8.
6.2.1Open from a design file
Once you have confirmed that the unit(s) can be “seen” by the software go to File Open navigate to the proper design file which will be an SDEC_xxxx .architect file. You should receive it from JBL Synthesis Technical Support via
- 10 -
SDEC
