2.Install the supplied lock body into the wood panel. The lock and key assembly is supplied with your wine chiller. Secure the lock body by using the supplied 15 mm lock retaining nut and screwing it on the lock body’s threaded section. Make sure that the lock’s key slot is vertical, then tighten the 15 mm nut with a 15 mm deep-well socket.

Lock body

Lock cam

Phillips

 

 

 

 

screw

Key

 

 

 

 

Lock

 

 

extension

 

Glass

 

ood

door

Door

 

gasket

W

 

panel

 

 

 

Lock retainer nut

3.Peel back door gasket on the glass door to provide access to the screw holes used to mount the wooden frame and the hole for the lock’s extension section at the top of the door.

4.Place the custom wood panel on a non-abrasive surface, protected by towels or rugs, to avoid accidental damage to the door finish.

5.Set the wood frame flush to the front of the door in the desired location clamp wood frame to the door if necessary. Check to see that the back of the lock in the wood frame lines up with the hole in the door.

6.Insert the wood screws through the back of the door into the pilot holes in the wood frame and tighten.

7.Assemble the door lock Phillips screw, lock extension, lock cam and mount them to the back of the lock body. Position the door lock cam so that it projects upward from the top of the door. Tighten the Phillips screw to secure the lock assembly.

8.Reinstall the door gasket by pressing into door channel. Make certain the corners are inserted fully. Insert the key into the lock and make sure the lock operates properly.

9.Install the door to the wine chiller. Use the washers (if provided) as shown on page 9.

10.Realigning the door may be necessary. Final door adjustments can be made using a 18" Allen wrench to adjust the door hinges (see figure below).

11.Attach the door to the wine chiller by reversing step number one above.

12.Make certain that the glass door swings freely, the door gasket seals properly and the interior light goes on and off as the door opens and closes.

13.Confirm that door lock turns a quarter turn from vertical to horizontal and that this locks the door closed.

14.Reconnect the power to the wine chiller. Return the control knob to its previous setting.

Magnetic door gasket

38" (1.0 cm)

clearance

holes for wood

frame wood

screws

Rear of door

Not required

for 4" toe kick

18" Allen head screws for

Light door

striker plate

hinge adjustment (top

 

and bottom of door).

 

Attached

Bottom of door

wood

Frame

 

10

Page 11
Image 11
Jenn-Air 41007605 warranty Lock