Jenn-Air 41007605 warranty Installation, cont, Reversing the Glass Door, Materials Needed

Installation, cont.

Reversing the Glass Door

WARNING

•To avoid electrical shock which can cause personal injury or death, disconnect power to the wine chiller before reversing the door.

The wine chiller door can have a left or right hand swing. Typically the door is installed on the wine chiller with a right hand swing configuration. To change to a left hand swing, follow the instructions listed below.

Materials Needed

•1⁄8" Allen wrench

•Phillips screwdriver with magnetic tip

•Needle-nose pliers

•5⁄16" nut driver

•Small flat-blade screwdriver

Black or white framed model:

• 15 mm deep-well socket and wrench

Custom wood frame or stainless steel frame overlay model:

• 15 mm open-end wrench

1.Note the thermostat control knob setting so you can reset the thermostat knob to its proper setting after the door reversal is complete.

2.Turn the thermostat control knob counterclockwise until the “OFF” setting is at the 12:00 position. The wine chiller’s refrigeration system will shut off.

3.Using the 1⁄8" Allen wrench, remove the screw from the top hinge of the wine chiller. Be sure to support the door so that it does not fall. Lift the door gently up and away from the bottom hinge.

4.Lay the glass door face down on a smooth, non- abrasive surface protected by towels or rugs to avoid accidental damage.

5.Using the 5⁄16" nut driver, remove the 5⁄16" hex head screws which are holding the top and bottom hinges. Set screws and hinges aside for later.

6.Using the Phillips screwdriver, remove the Phillips head hinge pin from the bottom hinge. Set the hinge, hinge pin and plastic washer aside for later.

For custom wood frame model, skip to step 12.

7.Pull the door gasket out of the door’s back frame, enough to allow access to the screw holes and the back of the door lock.

Lock body	Lock cam	Phillips
		screw
Key		Lock
		extension
	Glass
	door	Door
		gasket
	Lock retainer nut

8.Using the Phillips screwdriver, remove the Phillips screw at the end of the door lock. Set the Phillips screw lock washer, lock cam and lock/cam extension pieces aside for later.

9.Stainless steel frame overlay model only: Remove the ten screws that secure the stainless steel frame overlay to the glass door. Set the screws aside for later.

10.Black or white framed model: Use the 15 mm deep-well sock and wrench.

Stainless steel frame overlay model: use the 15 mm open-end wrench.

Loosen the retaining nut that secures the lock to the door frame. If the nut falls back into the door frame, use the needle-nose pliers to retrieve it and set the nut aside for later.

11.Gently lift the door end up where the lock is currently located and let the lock fall out and away from the door. Set the lock aside for later.

12.Using the Phillips screwdriver, remove the two screws holding the light striker plate to the back side of the door.

The following graphic shows the striker plate hole locations when changing to a left hand door swing.

Remove the light switch striker from the bottom of the right hand swing door and install the striker plate in the holes as shown.

Door

gasket

5⁄32" (0.4 cm) diameter two holes, striker plate

(Back view of glass door)

5