4.Position burner cartridge with the mixer tube openings and igniter rods toward the orifices and terminal receptacle. Slide cartridge until the tubes and igniters engage, then lower the cartridge so that it rests on the cooktop surface.
A
BC B
A.Sealed burner cartridge
B.Mixer tubes
C.Igniter rods
To Remove Sealed Burner Cartridge:
1.Be sure control knobs are in the “Off” position and cooktop is cool.
2.Lift up the edge of the cartridge until the bottom of the cartridge clears the basin.
NOTE: Lifting the cartridge too high while still engaged could damage the igniter rods and mixer tubes.
3.To disengage the cartridge, hold by the sides and pull away from the terminal receptacle and orifices. Lift out when fully unplugged.
A
Install Grill
The Grill can only be installed on the left side of the cooktop.
When using the grill, follow the guidelines below.
■Trim excess fat to reduce spattering. Slit the remaining fat on the edges to avoid curling.
■Allow space between food on the grill. Crowding food will result in uneven cooking.
■Use a metal spatula or tongs to turn food.
■Steaks, chops and hamburgers should be turned only once to avoid loss of juices.
■For best results, use top grade meat. Thicker meat will grill better than thinner cuts.
■When basting meats or applying sauces to foods, remember that excessive amounts accumulate inside your grill and do not improve the food flavor.
■Use only nonmetallic spatulas or utensils to avoid damaging the nonstick grill grate finish.
■Do not leave the grill unattended while cooking.
■To avoid damage to the grill, do not use aluminum foil, charcoal or wood chips.
■To avoid damage to cookware, do not place cookware on the grill when in use. Food should be cooked directly on the grill grate.
To Install Grill:
1.Be sure control knobs are in the “Off” position.
2.The orifices and terminal receptacle are located in the basin at the front of the cooktop.
A
BC B
A.Sealed burner cartridge
B.Mixer tubes
C.Igniter rods
BB
A. Terminal receptacle
B.Orifices
3.Position the grill burner with mixer tubes and igniter rod toward the orifices and terminal receptacle. Slide the burner until the tubes and igniter engage, then lower the burner until it rests in the burner basin.
A
IMPORTANT: Optional Sealed Burner Cartridge, model JGA8150AD, can replace the grill burner assembly. For more information see “Accessories” section.
B B
C
A. Grill burner
B. Mixer tubes
C. Igniter rods
8
