INSTALLATION
5.Lift top of drawer front to unhook the drawer from the slides. Lift door front out to remove.
To Install:
1.Pull both rails out to full extension.
2.While supporting door front, hook supports into slots located on inside of each slide.
Note
•All four drawer bracket supports must be in the proper slots for the drawer to function properly.
3.Lower door front into final position.
4.Replace and tighten Phillips screws that were removed from the drawer slides (select models).
5.Place the basket cradles back onto the drawer slides. Align basket cradle snaps with the slots on the drawer brackets and press each cradle towards the bracket until it clicks.
Basket cradle
snap attachments
6.Tilt the lower basket front down and set it down into the basket cradles.
Door Reinstallation
1.Install hinge assemblies:
•Install center hinge with Phillips screws.
2.Place hinge side of refrigerator door on center hinge pin.
•Install top hinge with 5⁄16” hex head screws.
3.While holding refrigerator door upright, tighten down top hinge with 5⁄16” hex head driver.
4.Reconnect
5.Replace top hinge covers.
Handles (style varies by model)
This handle style is installed at the factory. Style may vary by model.
Materials Needed:
•3⁄32” allen wrench
To Remove:
•Remove set screw from handle mounting post
using the 3⁄32” allen wrench.
•Repeat the procedure on all posts to remove the handle.
To replace:
•Align handle with the mounting posts.
•Fully tighten all set screws to secure handle in place.
6