Jenn-Air JRS203, JRS226 manual Installat o, Location, Important Leveling Information

Installat o

Location

If you are installing your new refrigerator yourself, please follow these helpful suggestions.

1.Remove base skids and reinsert two front levelers. Discard two rear levelers.

2. Remove all exterior and interior tape carefully and retain old tape. Make a small pad of this tape to pick off any remaining tape residues. This will eliminate the need to use dangerous solvents of any kind.

3. Remove and discard cantilever shelf	ll,,i,,lll_ll	I
packing clips located just above
each shelf where it hooks onto the
frame. To remove red plastic clip,
wiggle sideways and pull straight
out.

4.Select a location for your new refrigerator away from any heat sources. Allow a free flow of air through the front base grille.

5.Your model should not be installed where the room temperature will go below 55OF. because it will not run frequently enough to maintain proper temperature in the freezer.

Important Leveling Information

To enhance its appearance, maintain effi- cient performance, and for proper function

of the ice maker, your refrigerator should

be level. Using a carpenter's level, check		I TURNCLOCKWITOSE
to back and side to side. The front wheels
were adjusted at the factory so the doors
were properly aligned and the cabinet lev-
el. However, jarring in transit, or standing
the refrigerator on an uneven floor may			I ER
your refrigerator to make sure it is level front	__	_
cause the doors to shift out of alignment.		URNCOUNTER-CLOCKWISE

TO RAISE CABINET CORNER

If door alignment or leveling is necessary, remove the base grille and adjust the wheels with a screwdriver as shown (right).

To lock the cabinet in place, turn down one or both leveler feet, located near the front wheels. Rear leveler feet are not required.