Jenn-Air W10183782A manual Adjust Doors, Top Grille Panel, Door Alignment 36 91.4 cm Models

3.Slide the custom panels into the trims on the refrigerator door(s) and freezer drawer, making sure that the backer panel fits into the hinge side trims.

3.Remove one end cap by loosening the nuts and sliding the end cap off.

A

A

A.Panels

4.Reinstall the trims and corner caps.

5.Remove the skin from the screw covers. Snap the screw covers into the handle trim section.

C
B
D
A. Bottom rail	C. End cap
B. Nuts	D. Top rail

4.Slide the custom panel into the top grille channel and reattach the end cap.

A

A

A. Custom panel

5.Replace the top grille in the cabinet side trims and pull the panel down slightly to lock it into place.

BAB

A. Top grille

B. Cabinet side trims

Top Grille Panel

1.Grasp both ends of the top grille.

2.Push straight up; then pull straight out. Place the top grille panel-side down on a soft working surface.

BAB

A. Top grille

B. Cabinet side trims

Adjust Door(s)

Door Alignment (36" [91.4 cm] Models)

1.Loosen, but do not remove, the four Torx®† 27 flat-head mounting screws and the two ¹⁄₄" hex-head mounting screws in the top hinge.

2.Adjust the top hinge of the door to align it.

3.Tighten the Torx®† 27 flat-head mounting screws to a torque of approximately 100 inch-pounds (11.3 Nm).

4.Tighten the ¹⁄₄" hex-head screws.

A

B

A. Torx®† 27 flat-head mounting screws

B. ¹⁄₄" hex-head mounting screws

24