Jenn-Air W10183782A manual Door Height Adjustment 42 106.7 cm Models, A B C

Door Height Adjustment (42" [106.7 cm] Models)

Use the following steps to adjust the door height, up or down, after the refrigerator has been leveled.

NOTE: Adjust the right door to the position of the left door first. If it is necessary to adjust the left door, you must make sure that the hinged center rail located on the left-hand door does not drag when closing the door.

1.Open the freezer drawer. Remove the locking plate screw from the bottom side of the refrigerator door hinge using a

¹⁄₄" open-end wrench.

Door Swing Adjustment

36" (91.4 cm) Models

1.Check that the refrigerator door can open freely. If the door opens too wide, remove the door stop screw from the bottom hinge with a Torx®† T15 screwdriver.

A B C

A. Bushing

B. Locking plate

C. Locking plate screw

2.Remove the locking plate as shown.

A

A. Door stop screw

2.Hold the door open to a position that is less than 90°.

3.Replace the door stop screw in the bottom hinge and tighten.

IMPORTANT: Do not place the door stop screw in the 130° position on Overlay Series models. See “Handle and Door Clearances.”

3.Turn the bushing located underneath the bottom of the hinge using a ¹⁄₂" open-end wrench. Turning the bushing to the left will lower the door. Turning the bushing right will raise the door.

4.After adjusting, check the doors to make sure they are even at the top and bottom. If the doors are not even, continue to turn the bushing to adjust the door.

5.Replace the locking plate.

■Turn the bushing slightly to align the hinge and locking plate screw holes.

■Replace and tighten the locking plate screw.

6.Make final check to make sure the doors are aligned and even.

A B C

A.130°

B.110° (Overlay series)

C.90°

42" (106.7 cm) Models

1.Check that the refrigerator door can open freely. If the door opens too wide, you will have to adjust the door stop position.

2.Grasp both ends of the top grille.

3.Push the top grille straight up, then pull straight out. Lay the grille on a soft surface.

BAB

A. Top grille

B. Cabinet side trims

†®TORX is a registered trademark of Textron Innovations Inc.

25