4.Place the bottom tab of the blower box into the bottom mounting channel.
B
A
A. Blower box
B. Bottom mounting channel
5.Tilt blower box top tab so it is flush with the vent box panel and position it under the top mounting bracket. Slide bracket into the “Z” slots and tighten the 2 hex/slotted head screws to secure.
NOTE: Optional blower motor mounting position (opposite side). The blower motor box assembly can also be moved to the opposite side of the vent.
1.Remove blower motor box assembly. Follow steps 1 and 2 above.
2.Disconnect the wire connector from the blower motor (see Step 3 of rear venting).
3.Remove panel from the opposite side by loosening the screws in the “Z” slots and sliding the top bracket the same as for the motor box assembly.
4.Install the blower motor box assembly to the opposite side of vent box. Place in the position for the venting method for interior mounted motor, as required.
5.Reconnect wire connector to the blower motor.
6.Install panel cover to the opposite side of the blower motor.
Rear Venting:
1.Remove the vent box. Loosen the 2 hex/slotted head screws that attach the top bracket that secures the motor to the vent box enough to slide the bracket into the “Z” slots. This will move the bracket away from the top mounting lip of the blower box and allow it to tilt away from the vent box panel.
A
B
B
A. Bracket with “Z” slots
B. Hex/slotted head screws (2)
2.Lift up the blower box from the bottom mounting channel and set aside.
B
A
A. Blower box
B. Bottom mounting channel
3.Disconnect the wire connector from the blower motor.
A
B
A. Blower motor
B. Wire connector
10
