10.Place the bottom tab of the blower box into the bottom mounting channel.
B
A
A. Blower box
B. Bottom mounting channel
11.Tilt blower box top tab so it is flush with the vent box panel and position it under the top mounting bracket.
12.Slide bracket into the “Z” slots.
13.Tighten the 2 hex/slotted head screws to secure.
14.Place the small vent cover over the hole in the vent box and secure in place with the 4 screws.
Complete Installation
1.Attach backdraft damper over 6" vent extension. Secure with vent clamp.
B
A
A. 6" vent extension
B. Backdraft damper
2.Remove screw attaching the terminal box cover.
A
A. Terminal box cover
Determine which direction (rear or bottom) electrical connection will need to run from vent system terminal box. Remove rear or bottom knockout and install a UL listed or CSA approved conduit connector.
3.Insert downdraft vent into countertop cutout. Using 2 or more people, position downdraft vent so it is centered in cutout and parallel to edge of cutout. Check that downdraft vent is level vertically. Then fasten lower support legs to the cabinet floor with screws.
12
