Jensen CM715K specifications Test Speaker Connections, Balance, Fader

®

CM715K

Test Speaker Connections

These tests make sure the speakers are connected right. If speakers don’t play at all, both wires may not be connected. If the wrong speaker plays (you hear front speakers when you expect rear speakers) make sure you connected the wires right.

Balance

1	+		T-IN	LOC SCN RPT	MTL AMS PGM RDM
	SEL
	SEL			LOUD
	SEL	0
	SEL
	+			II

1.Press SEL four times. BAL appears in the display.

2.Hold VOL on the control button until the display shows L 12.

2	+	T-IN	LOC SCN RPT	MTL AMS PGM RDM
	0		LOUD
VOL	+		II

Fader

4	SEL	+	T-INLOC SCN RPT MTL AMS PGM RDM
	SEL
	SEL		LOUD
	SEL	0
	SEL
		+	II

4.Press SEL five times. FAD appears in the display.

5.Hold VOL on the control button until the display shows R 12.

5	+	T-IN	LOC SCN RPT	MTL AMS PGM RDM
	0		LOUD
VOL	+		II

VOL

Only the left speakers should be playing.

If not, check the wiring. Make sure you con- nected the wires just like the chart on page 6.

3.Hold VOL on the control button until the display shows R 12.

3	VOL	+	T-IN	LOC SCN RPT	MTL AMS PGM RDM
		0		LOUD
	VOL	+		II

VOL

Only the front speakers should be playing. If not, check the wiring. Make sure you con- nected the wires just like the chart on page 6.

6.Hold VOL on the control button until the display shows F 12.

6	VOL	+	T-IN	LOC SCN RPT	MTL AMS PGM RDM
		0		LOUD
	VOL	+		II

Only the right speakers should be playing. If not, check the wiring. Make sure you con- nected the wires just like the chart on page 6.

Only the rear speakers should be playing. If not, check the wiring. Make sure you con- nected the wires just like the chart on page 6.

9

Untitled-3 9 4/10/99, 7:38 PM