Jensen JMC-255 instruction manual CD Operation, Play/Pause Mode

CD OPERATION

THIS PLAYER PLAYS NOT ONLY COMMERCIAL CD’S BUT ALSO CD-RW DISCS.

•Because of non-standardized format definition/production of CD-R/RW, playback quality & performance are not guaranteed.

•Manufacturer is not responsible for the playability of CD-R/RW due to recording conditions such as PC performance, writing software, media ability, etc.

•Do not attach a label or seal to either side of the CD-R/RW disc. It may cause a malfunction.

Note: If skipping occurs during CD playing, try turning the volume down. Do not open the CD DOOR when CD is playing.

1.Open the CD DOOR by pressing the CD DOOR at the “PUSH OPEN” mark located on the CD door.

2.Insert a CD disc into the CD Compartment with the label facing up and close the CD DOOR.

Note: Ensure the CD DOOR is closed properly and locked in place.

3.Set the FUNCTION SWITCH to the “CD” position.

4.Press the POWER BUTTON once. The Player will start reading the CD.

The total number of tracks on the disc

will be shown in the LCD DISPLAY after a few seconds.

Note:

i.If there is no disc inside, “” will be shown in the LCD DISPLAY.

ii.If the CD DOOR is not closed, the LCD

DISPLAY will show “ ”.

Play/Pause Mode

5.When the PLAY/PAUSE "# BUTTON is pressed during CD stop mode, the first track will be played. The Play Indicator “"” will be shown in the LCD DISPLAY. The LCD DISPLAY will show the specific number of track being played.

7