15
2. Never wrap the earphone lead around any animal or person. Special care should be ta ken with lon g wires. 3. Clean your uni t with a damp (ne ver wet) cloth. Solvent or dete rgent should never be used. 4. Avoid leaving your unit in direct sunlight or in hot, humid or dusty places. 5. Keep your unit away from heating appliances and sources of electrical noise such as fluorescent lamps or motors. 6. If drop-ou ts or interru ptions occur in the mus ic during CD play, or if the CD
fails to play at all, its bottom
surface may require cleaning. Before playing, wipe the disc fro m the cen ter outwards with a g ood soft cleaning clo th.
TROUBLE SHOOTING GUIDE
If you experience difficulties in the use of this music system please check the following or call 1 800 777 5331 for Customer Service and Support.
Symptom Possible Cause Solution
Noise or sound
distorted on AM or
FM broadcast
Station not tuned properly for AM or
FM.
FM: Wire antenna is not extended.
AM: The bar antenna is not
positioned correctly
Retune the AM or FM
broadcast station.
FM: Extend FM Wire antenna.
AM: Reposition the unit until
the best reception is obtained.
AM or FM no sound Unit not in RADIO function mode.
Volume set at minimum Slide Function Selector to
RADIO position
Increase Volume
CD player will not
play
Unit not in CD function mode.
CD is installed incorrectly.
It the CD is self-compiled, the media
used may not be compatible with the
player.
Select CD function mode.
Insert CD with label side up.
Use better quality blank media
and retest.
CD skips while
playing Disc is dirty or scrat ched. Wipe CD with clean cloth or use
another disc.
Intermittent sound
from CD Player
Dirty or defective dis c
Dirty pick up lens
Player is subject to excessive shock
or vibration
Clean or replace the defective
disc
Use a CD-lens cleaning disc to
clean the lens
Relocate the player away from
shock or vibration
No sound when
played in the AUX
Mode
Power to external source (CD, MP3
etc) not switched on
Connection to external source
(CD, MP3 etc) is incorrect: e.g.
RCA plug may have been
inserted to AUDIO IN of exte rnal
source.
Master Volu me is at minimum.
Switch on the power of the
external source.
Reconnect the RCA Plug to
the AUDIO OUT of the
external source.
Adjust the master volume