MP6612i
WIRING
NOTE: The amplifier in this radio is only designed for use with four speakers. Never combine (bridge) outputs for use with two speakers. Never ground negative speaker leads to chassis ground. Failure to wire exactly as shown may cause electrical damage to the radio.
NOTE: Only connect speakers with a nominal impedance of 4 ohms. Speakers with a load impedance less than 4 ohms could damage the unit.
DATA BUS
DATA BUS
SAT L SAT R SAT
3.5mm
Audio Only
Ground
Connect to ground terminal or clean, unpainted part of chassis.
Black
Memory/Battery
Connect to battery or 12 volt power source that is always live. The radio will not work if this wire is not connected.
Yellow
FRONT SP
Rear Line out | R (Red) |
Gray | L (White) |
FrontLine out | R (Red) |
Black | L (White) |
Power Antenna
Connect to power antenna or amplifier. If not used, tape bare end of wire.
Blue
Accessory/Ignition
Connect to existing radio wire or radio fuse.
Red
REAR SP
iPod Video | iPod |
|
| iPod Mini iPod Nano | |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
White/Black | White Gray/Black | Gray | Green/Black | Green Purple/Black | Purple |
Stripe | Stripe |
| Stripe | Stripe |
|
jLink iPod Cable | Left Speaker | Right Speaker | Left Speaker | Right Speaker | |
(Sold Separately) | |||||
(Front) | (Front) | (Rear) | (Rear) | ||
|
5
