Jensen MP6612i Satellite Radio Operation, Accessing Satellite Radio Mode, Selecting a Station

MP6612i

SATELLITE RADIO OPERATION

Listeners can subscribe to XM® Radio on the Web by visiting www.xmradio.com, or by calling (800) 967-2346. Customers should have their Radio ID ready (see “Displaying the Identification (ID) Code”). Customers can receive a limited number of free-to-air channels without activation.

Listeners can subscribe to Sirius® Radio on the Web by visiting www.sirius.com, or by calling (888) 539-SIRIUS. Customers should have their Sirius ID ready (Sirius ID is located on the Satellite Radio Tuner, sold separately). Customers can listen to music samples by tuning to channel 184.

Accessing Satellite Radio Mode

To switch to Satellite Radio mode, press SRC (7) until “- - SAT - -” appears on the display. This will not be displayed unless the unit is connected to an optional XM or Sirius receiver.

MP6612i
		P
			H
			O	TUNE / TRACK
			N
			E	/
				DISP	PTY
D				RADIO
				READY	CH/CAT
N
A			C
B		R		SCAN	AS
	S
MENU/ENTER-PRESS

1	2 INT	3 RPT	4 RDM	5 DN	6 UP	iPod
						Menu

Displaying the Identification (ID) Code

Before you listen to Satellite Radio, you must subscribe to the service using your radio’s identification number. To display the radio ID, press the TUNE/ TRACK << button (19) to access channel 000. The screen displays “RADIO ID” followed by the ID number.

Selecting a Station

Press the TUNE/TRACK >> or << button (19) to change to another station.

Preset Stations

Press the BAND button (3) to change between three SAT Radio bands. Each band stores up to six preset stations. You can store and recall a total of 18 preset stations.

Store a Station

1.Select a band (if needed), then select a station.

2.Hold a preset button (14) for three seconds. The preset number appears in the display.

Recall a Station

1.Select a band (if needed).

2.Press a preset button (14) to select the corresponding stored station.

Direct Tuning Mode

To enter a station directly, perform the following steps.

1.Press the AS button (15).

2.Press the MENU button to select “Direct Tune”.

3.Turn the rotary encoder to select the third digit of the desired channel (0-9).

4.Press MENU (22) to enter the number and move to the second position.

5.Turn the rotary encoder again to select the second digit of the desired channel (0 - 9).

6.Press MENU to enter the second number and move to the first position.

7.Turn the rotary encoder again to select the first digit of the channel you want to tune to (0 - 2).

8.Press MENU to enter the final number and access the channel.

NOTE: If the channel is unauthorized or invalid, “Unavail” appears on the LCD and the unit returns to SAT mode.

18