UV8035
position it. CAUTION: The rear of the radio must be supported with the strap to prevent damage to the dashboard from the weight of the radio or improper operation due to vibration.
Dashboard
Support Strap
Plain Washer
Screw (5 x 25mm)
2.Insert the removal keys straight back until they click, and then pull the radio out. If removal keys are inserted at an angle, they will not lock properly to release the unit.
Dashboard
Hex Nut (5mm) Spring Washer
Screw Stud
Removal Key
9.Test radio operation by referring to the operating instructions for the unit.
Trim Plate Installation
Push the trim plate against the chassis until it is fitted. You must do this before you install the control panel, otherwise it can't be attached.
Removing the Unit
To remove the radio after installation:
1.Insert fingers into the groove on the front of the frame and pull out to remove the frame.(when
4
