Jet Tools DC-1100CK Electrical Connections, Turning the Machine On & Off, All Models, B

Electrical Connections

All electrical connections must be done by a qualified electri- cian. All adjustments or repairs must be done

with the dust collector disconnected from the power source, unplugged. Failure to comply may result in serious injury!

The DC-1100 (all models) dust collectors are rated at 115/230V, Prewired 115V. Use a plug and outlet rated at least 20 amps. The circuit for the machine should also be protected by at least a 20 amp circuit breaker or fuse. Keep in mind that a circuit being used by other machines, tools, lights, heaters, etc. at the same time will add to the electrical load.

A dedicated circuit to the dust collector will give you the best results since dust collectors are generally used at the same time other tools are running.

Turning the Machine On & Off

This machine is intended for indoor use only.

All Models

Before hooking up to the power source, make sure that the switch is in the off position.

Turn the dust collector on by pressing the Start button mounted next to the motor. Press the Stop button to turn off the dust collector.

Remote Control (Optional Accessory)

The DC-RC RF Remote Power Control unit is available as an optional accessory (contact Customer Service by calling the number on the cover).

Important: The DC-RC Remote Power Control (SN 708636C) can be used for activating Dust Collection units powered by 115V only up to 1-1/2HP. If your dust collector is currently set up for 230V operation or you choose to convert it to 230V at a later time, you must purchase the DC-RC230 Remote Power Control unit (SN 708636D).

Figure 12A Figure 12B

Dust Collector RF Remote Power Control (Optional)

The DC-RC Remote Power Control (Figure 1) should be used for activating Dust Collection units powered by 115V only up to 1-1/2HP. The DC-RC Remote Power Control unit is rated at 115V, Single Phase only. Use an outlet rated at least 20amps. The circuit for the device being controlled by the DC-RC should also be protected by at least a 20 amp circuit breaker or fuse.

Before hooking up to the power source, make sure that the switch is initially in the off position on both the dust collector and remote control unit (Figure 12).

Turning the DC-RC On & Off

This machine is intended for indoor use only.

1.Plug the dust collector into the main unit (Figure 13) and plug the main unit into the power outlet.

To start a machine or device:

2.Turn the machine itself on.

3.On the main unit place the switch to the ON position (Figure 12A). The red LED on the main unit should light up.

4.Press the button on the remote control transmitter (Figure 13) to turn the machine on.

5.To stop the machine, press the button on the remote control transmitter again.

Figure 13

When the machine is running, it can be stopped by placing the switch on the main unit in the off position (Figure 13). To restart, repeat steps 3 and 4.

13