Adjusting Vise Square to the Blade

1.Disconnect the machine from the power source.

2.Place a machinist'ssquare on the table against the blade and the vise. The square should lie along the entire length of the vise and blade without a gap.

3.If adjustment is necessary, loosen bolts holding the vise and adjust vise so square lines up properly. Tighten bolts.

4.Connect machine to the power source.

Changing Blade Speeds

it. WARNING

Disconnect the machine from the power source before making any repair or adjustment!

Failure to comply may cause serious injury!

1.Disconnect machine from the power source.

2.Open pulley cover by supporting the belt cover with one hand while removing the belt cover lock knob with the other. Lower guard gently to its full open position.

3.Support motor with one hand while loosening lock handle (A - Fig. 6). Lower motor gently.

4.Position belt in grooves according to the speed selection chart.

5.Tension the v-belt by pushing down on the motor and tightening the lock handle on the motor tilt plate. Correct tension is achieved when finger pressure on the belt between the

two pulleys causes approximately a 1/2" deflection.

6. Close pulley cover and fasten.

Fig. 6

 

7.Connect machine to the power source.

5

Page 9
Image 9
Jet Tools HBS-1018W, HBS-916W manual Adjusting Vise Square to the Blade, Changing Blade Speeds