Jet Tools JJ-6CSDX Installing Belt Guard, Installing Cutterhead Guard, Installing Access Cover

Installing Belt Guard

Referring to Figure 6:

1.Place the belt guard (A) over the opening in the stand.

2.Line up the holes in the stand with the holes in the guard.

3.Attach the guard to the stand using four 1/4-20 x 1/2’ pan head machine screws (B) and four 1/4” flat washers (C).

Installing Cutterhead Guard

1.Remove the screw from the guard post. Referring to Figure 7:

2.Turn spring knob (B) approximately one and one half revolutions counter-clockwise (as viewed from the top) and hold.

3.Insert the guard post into hole in table. Make sure that the spring inside the spring knob (B) engages the slot in guard post.

4.Thread the screw (C) back into the guard post.

5.Check for proper operation. The cutterhead guard (A) must return fully to the fence when released. If guard does not return fully, pull guard, apply more tension to the spring knob

(B)by turning it another half turn counter- clockwise, and re-insert guard. If guard closes too quickly and strikes fence too hard, release some tension on the spring.

6.Insert screw (B) back into the guard post.

Installing Access Cover

Referring to Figure 8:

Install access cover (A) by placing bottom of panel in the stand and fastening with four #5-40 x 3/8" pan head screws and four flat washers (B).

Installing Dust Chute

Referring to Figure 8:

Attach the dust chute (C) to the base with four 1/4" x 1/2" machine screws and four 1/4" washers (D).

Figure 6

Figure 7

Figure 8

11