8
Mounting Sa nding Sleeves
1. Thor oughly clean the arbors (A, Fig. 1) on all
of the spindle assemblies. Also clean the
arbor housi ng on the sander.
2. Slip the sanding sleeve (B, Fig. 1) over the
spindle and hold in place by tightening the
set screw (C, Fig. 1) with the supplied 2mm
hex wrench.
3. Repeat for all of the steel spindle
assemblies.
4. To protect the sanding assemblies place
them in the holders found on t he sides of the
sander, see Figur e 2.
Installing Sanding Assemblies
WARNING
Disco nnect the sander from the power
source when instal li ng or remo ving sand in g
assemblies.
Fai lure to comply may cause seri ou s in ju ry!
1. Thoroughly clean the arbor and arbor
housing before installing the sanding
assemblies.
2. Thread the arbor (A, Fig. 3) into the arbor
housing (B , Fig. 3).
3. Use the provided wrenches to hol d the lower
arbor housing nut (C, Fig. 3) while turning
the arbor nut (D, Fi g. 3) cl ockwise.
Removing Sanding Assemblies
1. Disconnect the sander form the power
sour c e , unpl ug.
2. Use the provided wrenches to hold the
upper arbor housing nut (E, Fig. 3) while
turning the arbor nut (D, Fig. 3) counter-
clockwise.