Jet Tools JWBS-10OS Shipping Contents

Shipping Contents

Remove all contents from the shipping carton. Do

not discard the carton or packing material until the

band saw is assembled and is running

satisfactoril y.

Compare the contents of the carton against the list

of parts in Contents of Shipping Container (below).

The letter identification in the list corresponds to the

items shown at right. This is your key for identifying

the parts used throughout the Assembly section for

easy reference.

Remove the protective coating that is applied to the

table with a house hold grease and spot remover.

01 Band Saw (A)

01 Table Insert (B)

01 Table (C)

01 Miter Gauge (D)

01 Fence (E)

01 Rail Guide (F)

04 Stand Leg (G)

02 Short Support Plate (H)

02 Long Support Plate (J)

01 Owner's Manual (not shown)

01 Warranty Card (not shown)

01 Hardware Bag (see below for contents)

(p/n JWBS10OS-HB)

01 Hex Wrench 3mm (K)

01 Combination Wrench 10/13mm (L)

04 Rail Lock Knob (M)

04 Rubber Foot (N)

01 M6x32 Hex Cap Screw (O)

04 M6x12 Hex Cap Screw (P)

16 M8x16 Carriage Bolt (Q)

20 M8 Flat Washer (R)

16 M8 Hex Nut (S)

01 M6 Hex Nut (T)

04 M6 External Tooth Lock Washer (U)

Tools Required for Assembly & Adjustments

The tools listed below are not included but are

required for assembly.

2 14mm Open End Wrench

1 Cross Point Screw Driver

1 Combination Square

Shipping Contents