Loosen the hex cap screw (G, not visible) with a 10mm wrench and adjust the entire assembly back or forth to just clear the back of the saw blade. Tighten screw (G), then fine tune the adjustment by repeating the first part of this step.
6.Secure the roller guide (A) by tightening the thumbscrew (B, upper guide) or setscrew (B, lower guide).
Guide Bearing Adjustment
Disconnect machine from the power source! Never make adjustments with the machine running! Failure to comply may cause serious injury!
Referring to Figure 13:
1. Disconnect machine from power source.
Note: Blade must already be tensioned and track- ing properly (Adjusting Blade Tension, page 11).
2.For the upper blade guide, loosen two thumb- screws (E). For the lower blade guide, loosen two setscrews (E) with the 3mm hex wrench provided.
3.Slide the adjustment shaft (F) to position each roller guide (D) approximately 1/16" behind the gullets of the saw blade.
The roller guide (D) is mounted on a concentric shaft (F). When the shaft is rotated, the relative position of the guide to the blade can be changed.
4.Rotate each adjustment shaft (F) to position the guides (D) within 1/32" of the saw blade.
5.Secure the roller guides (D) by tightening thumbscrews (E, upper guide) or setscrews (E, lower guide).
Figure 13
Operating Controls
On/Off Switch – located on front of machine: pull switch out to start; push switch in to stop. When yellow safety key is removed, machine will not start.
Work Lamp Switch – located on front of machine above On/Off switch. Turns LED work lamp on and off.
13
