Jet Tools JWBS-14OCS operating instructions

IMPORTANT: When moving the pulleys, do not position them beyond the end of the shaft. Both pulleys must fully engage the shaft and the key.

7.Open the lower door, and place the v-belt around the motor pulley and the wheel pulley (see Figure 13).

8.Loosen the nuts on the four motor mounting bolts (Figure 15) and tension the v-belt by pushing down on the motor. Tighten the four motor mounting nuts.

Figure 15

9.The v-belt is properly tensioned when finger pressure between the two pulleys causes approximately 1/2" deflection (Figure 16).

Figure 16

10.Screw the two small knobs (Figure 17) into the threaded holes in the saw body. Slide the pulley cover down over the knobs, and tighten the knobs.

Figure 17

11.Attach trunnion support bracket to saw body with two M8 x 30 hex cap screws and two M8 lock washers, as shown in item D, page 8. See Figure 18.

12.Thread nut onto table stop bolt (Figure 18) and attach to trunnion support bracket as shown.

Figure 18

13