Cont.

From

Previous

Page

➔

➔

➔

➔

STEP 12: Remove the OEM wire harness from the plastic track. Wrap the OEM wiring in black tape.

STEP 13: With the OEM wiring harness out of the way, you need to cut the carpet.

SIDES: From the tape outline of the center con sole, measure inward to middle of the transmission tunnel 1.5” from the tape. Mark and cut, front to back.

FRONT: Cut left to right at the front area where the outline starts to taper inward.

REAR: Feel for the black plastic mounting bracket. Cut left to right at the transmission tunnel, behind the black plastic mounting bracket.View picture.

STEP 14: With the OEM carpet and the jute(sound deadening) cut out. Position the supplied pair of 3”x3” wax squares in place.

Make sure that the wax square is placed and with the adhesive down and positioned as in the picture.

STEP 15: Thread the supplied pair of socket cup set screws into the Stealthbox. Leaving about 1/4” exposed.

Position the Stealthbox into the mounting location and firmly press down.

The Stealthbox is molded to mirror the floor. It should tuck right in.

➔ ➔ ➔

STEP 16: When the Stealthbox is removed, the wax square should have the impressions of the socket cup set screws.

STEP 17:*CAUTION*

Before drilling, make sure that you are not going to be drilling into any gas lines, brake lines, transmission lines, electrical wiring, transfer case(4x4 vehicles) or anything else that might cause a reduction in your weekly pay. Always wear eye protection when drilling.

With the use of a 1/2” drill bit and drill. Drill out the floor at the’ impressions on the wax squares.

STEP 18: The wire harness from STEP 12 needs to be rerouted over to the other side of the structure support bar under the dash.

Also at this time, run the speaker wire form the amplifier location to the Stealthbox location.

Double check the woofer for correct functioning.

STEP 19: With the wire harness properly tucked under the carpet, use double sided tape(not sup- plied) to secure the carpet to the metal floor.

If the carpet is not secured to the floor, it will bunch up after the OEM console is reinstalled.

Remove the masking tape that outlined the OEM console from STEP2.

Continued on Next Page ➔

w w w . j l a u d i o . c o m

SB - GM - BURBCNSL/10W3v2, JL AUDIO, Inc 2005

Pag e 3

Sheet SKU#011167 3/08/2005