JL Audio STEP, STEP, STEP29:, STEP 28:, STEP 33:, STEP 34: Time to cut. Using a wheel saw or

Cont.

From

Previous

Page

➔ ➔

➔ ➔

➔

➔

STEP 28: This is a view of the driver’s side, front area.

The mark lines needs to follow this edge forward, to this mounting leg.

(Arrow) The mark line needs to follow up this mounting leg and stop at this upper wall edge.

STEP29: The mark line needs to follow around this mounting leg. Follow this inside edge to the front.

STEP 30: The mark line needs to jet up slightly to this front edge. Mark across this edge from the dri- ver’s side to the passenger’s side.

STEP 31: These next three STEPS are just mirroring STEPS 27,28 & 29.This is for the passenger’s side of the inner console.

The mark line needs to follow across to this passen- ger’s side mounting leg. Using this inner edge as a guide.

➔ ➔ ➔

STEP 32: The mark line needs to come around this leg. Go down to the inner edge of this flat lip.

STEP 33: Follow the inner edge of this flat lip, straight back. Again, do not follow this inner edge as it curves up.

STEP 34: Time to cut. Using a wheel saw or	STEP 35: This is the view of the front, from
blade saw will be easier to use, then a jig saw.	STEP 28.
Follow the mark lines with the cutting tool.
This is the view of the driver’s side, from STEP 27.

Continued on Next Page ➔

w w w . j l a u d i o . c o m SB - GM - BURBCNSL/10W3v2, JL AUDIO, Inc 2005 Pag e 5 Sheet SKU#011167 3/08/2005