Cont.
From
Previous
Page
➔ ➔ ➔
STEP 36: This the view of the passenger’s side, | STEP 37: This is the view of the upper pocket, |
| from STEP 29. | that needs to be removed. |
| The mark lines follow the bottom, using this edge as |
| a guide. |
➔ ➔
STEP 38: The passenger’s side mark line goes from the bottom mark line from STEP 37, angling up to the upper corner of this exposed upper wall.
➔
STEP 39: The driver’s side mark line goes from the bottom mark line from STEP 37, angling up to this upper corner of this exposed upper wall.
➔
STEP 40: The upper mark line goes across the top, using this exposed front edge.
After all cutting is completed. Reassemble the inner console and outer console back together.
STEP 42: Place the OEM console into the vehicle. Sleave the OEM console over the Stealthbox. Make sure that the OEM consoles mounting legs are placed back over the OEM position studs.
STEP 43: When the OEM console is place over the Stealthbox. It should be snug.
If there are any obstructions, that do not allow the OEM console to fit properly.Trimming of the inner console is needed. Mark the obstruction and cut only what is needed.
Continued on Next Page ➔
w w w . j l a u d i o . c o m | SB - GM - BURBCNSL/10W3v2, JL AUDIO, Inc 2005 | Pag e 6 | Sheet SKU#011167 3/08/2005 |