TWEETER INSTALLATION:
First, run speaker wires from the tweeter output of the crossover (see diagrams on page 5) to the desired tweeter mounting locations, observing the same precautions as mentioned in the woofer installation section. Terminate the wires with the supplied 2.8 mm male crimpable connectors.
TWEETER FiXTURE INSTALLATION: The dome tweeters supplied with your
ZR650-CSi system have been designed for maximum mounting versatility. There are two primary methods by which the tweeters can be mounted in your vehicle:
Flush-Mount: Two different styles of flush-mount fixtures are provided: a compact, simple design and an enhanced design. Both are installed using the same method (shown in Diagram E), but require different size mounting cutouts. Refer to page 2 for cutout dimensions.
Flush-mounting yields a custom-installed appearance, but will require at least 3/4-inch (19
mm)of clearance behind the mounting surface of the tweeter. Install as shown in Diagram E, using the spring clips and 1-inch machine screws (it may be necessary in some limited depth applications to cut down the length of the machine screw, or use a shorter screw (not supplied). Hand-tighten the machine screw until the fixture is secure.
Surface-Mount: In this application, you will not need to cut large holes in your vehicle’s panels for the tweeters. You will only need to drill a hole for the wires and two smaller holes for the mounting screws. This application is useful when mounting the tweeters to a panel that has insufficient clearance behind it for the tweeter’s magnet structure.
Using the fixture as a template, mark the screw hole locations and a location in the center of the fixture for the wire hole. Remove the fixture and drill pilot holes for the screws and a 1/8-inch (3
mm)for the wires. Use the supplied #6 x 5/8-inch sheet metal screws to secure the fixture as shown in Diagram F (hand-tighten). Run the tweeter's wires through the hole and insert the tweeter until it snaps into place.
