Johnson Controls PD 180 THRU 240 dimensions Configured Split Condenser Model Number Nomenclature

430645-YIM-D-0610

Nomenclature

Configured Split Condenser Model Number Nomenclature

P

C

240

C00

A

2

A

AA

2

A

Product Style

Product Category

A = Style A

P = Split System, Condenser, HP, R-410A

Product Generation

Product Identifier

1 = First Generation

2 = Second Generation

C = Standard Efficiency, 2-Pipe, R-410A

D = Standard Efficiency, 4-Pipe, R-410A

Product Options

Nominal Cooling Capacity - MBH

Installation Options

AA = None

AB = Phase Monitor

A = None

090 = 7.5 Ton

AC = Coil Guard

B = Option 1

120 = 10 Ton

AE = Phase Monitor + Coil Guard

C = Option 2

150 = 12.5 Ton

LA = Low Ambient

D = Options 1 & 2

180 = 15 Ton

LB = Low Ambient + Phase Monitor

S = Options 5

240 = 20 Ton

LC = Low Ambient + Coil Guard

T = Options 1 & 5

LD = Low Ambient + Phase Monitor

Options

+ Coil Guard

Heat Type & Nominal Heat Capacity

1 = Disconnect

LE = Low Ambient + Technicoat Cond. Coil

C00 = Cooling Only

2 = Non Pwr’d Conv Outlet

LF = Low Ambient + Technicoat Cond. Coil

5 = Pwr’d Conv Outlet

+ Phase Monitor

LG = Low Ambient + Technicoat Cond. Coil

+ Coil Guard

Voltage

LH = Low Ambient + Technicoat Cond. Coil

+ Phase Monitor + Coil Guard

2 = 208/230-3-60

TA = Technicoat Condenser Coil

4 = 460-3-60

TB = Technicoat Condenser Coil + Phase

5 = 575-3-60

Monitor

7 = 380/415-3-50

TC = Technicoat Condenser Coil + Coil Guard

Airflow

TE = Technicoat Condenser Coil + Coil Guard

+ Phase Monitor

A = Standard Motor

General

These condensing units are designed for outdoor installation on a roof or at ground level. Every unit is completely piped and wired at the factory and is shipped ready for immediate installation. Only the liquid and suction lines to the evaporator coil, the filter drier, the thermostat wiring and the main power wiring are required to complete the installation. Each unit is dehydrated, evacuated, leak tested and pressure tested at 450 psig before being pressurized with a holding charge of refrigerant R-410A for shipment and/or storage.

All controls are located in the front of the unit and are readily accessible for maintenance, adjustment and service. All wiring (power and control) can be made through the front of the unit.

This Split-System (Air Condensing / Heat Pump / Air Handling) unit is one component of an entire system. As such it requires specific application considerations with regard to the rest of the system (air handling unit, duct design, condensing unit, refrigerant piping and control scheme).

Failure to properly apply this equipment with the rest of the system may result in premature failure and/or reduced performance / increased costs. Warranty coverage specifically excludes failures due to improper application and Unitary Products specifically disclaims any liability resulting from improper application.

Please refer to the equipment Technical Guide, Installation Manual and the piping applications bulletin 247077 or call the applications department for Unitary Products @ 1-877-UPG-SERV for guidance.

2 Johnson Controls Unitary Products