E N G L I S H
Basic Working Techniques
Boring Cut
A boring cut is used to fell large trees. Follow the steps listed below when performing a boring cut.
| 1. Cut, using the bottom portion of the guide bar tip, |
STEP 1 | until the depth of the cut is equal to the width of the |
guide bar and deep enough to stop a kickback during | |
| steps 2 and 3. |
2. Operating at full throttle, align the saw with the direction of cut.
STEP 2
3. With saw at full throttle, press the guide bar straight into the trunk.
| STOP WARNING! | |
| Making a boring cut can be dangerous if improperly | |
STEP 3 | performed. Only properly trained operators should | |
attempt this technique. | ||
| ||
|
|
26