Brick Panel Assembly
CAUTION: THESE PANELS ARE EXTREMELY FRAGILE! SUPPORT EACH PIECE WITH BOTH HANDS AND HANDLE TENDERLY.
Install the optional Brick Panel Kit 155311 before placing the Logset. Place the panels in position in the order as numbered in Fig. 17. No fasteners or tools are required.
Upper Rear Panel,
220515
4
31
Lower Rear Panel,
220514
Left Side Panel, 220516
Figure 17. Panel installation order.
2
Right Side Panel, 220517
Pull Frame Latches to
Release Frame
Figure 18. Glass Frame latch locations.
1.Remove the Glass Frame, if you have not already done so. Remove the Ashlip and locate the two frame latches under the firebox floor. See Fig. 18. Pull the latch handles forward to disengage them from the bottom of the glass frame. You can then pull the frame out and up off of the three retainer tabs at the top of the firebox opening. Set the Glass Frame out of the way.
2.Remove the Fettle and Logset. These parts are not fastened. Simply lift them out of the firebox.
3.Install the Lower Rear Panel. Orient the panel so that the cutout is at the bottom. Engage the bottom edge between the rear wall and the firebox base. See Fig. 17.
4.Install the Side Panels. Engage the bottom edge of each side panel between the Logset Base and the firebox wall and push the panel forward against the front lip of the firebox opening. See Fig.20.
5.Install the Upper Rear Panel. This will also be a snug fit. Set the panel up high and then carefully lower it to seat its lower edge against the top of the other rear panel. The side panels will hold it in place.
6.Install the Logset (see pg. 20).
7.Replace the Fettle, Andirons and Glass Assembly.
Logset Base
Figure 19. Install Lower Rear Panel.
Side
Panel
Figure 20. Install the Side Panel.
19