below within the next few days. Please use one white cleaning tablet (enclosed). The machine comes with a pack of 2 tablets. To
Important: Once the cleaning program has started do not interrupt the procedure.
1.Make sure the machine is on and the water tank is full. 2.Push the Rinse button. The display shows EMPTY TRAY. 3.Remove and empty the drawer and used coffee container and
replace complete assembly (Fig. 21) TRAY MISSING.
Important: Even if the drawer and the used coffee container are empty, you still need to remove the drawer for approx. 20 seconds and then replace it. The display shows PRESS RINSE.
4.Place a 12 oz. container under the coffee spouts. 5.Push the Rinse button. The display shows CLEANING.
After a moment the display shows ADD TABLET.
6.Open the ground coffee lid and drop in one white cleaning tablet (Fig. 22)and close lid. PRESS RINSE. The F7 comes with two tablets. To order more tablets see chapter 22.
7.Push the Rinse button. The display shows CLEANING. The cleaning program will dispense hot foamy water in intervals through the coffee spouts.
8.When finished, the display shows EMPTY TRAY.
9.Lift and remove the drawer. Empty the used coffee container and drawer and replace. The display shows READY indicating the machine is now ready to brew coffee again.
Attention: You can run a tablet cleaning cycle at anytime even if the machine does not prompt you,
• READY. Push and hold the Rinse button until display shows
EMPTY TRAY.
• Continue with step 3 above.
20c. DECALCIFYING PROCEDURE
The machine has an integrated decalcifying program. When the display shows DECALCIFY / READY it is time to decalcify the machine. You can still make coffee. However, it is highly recom- mended that you decalcify the machine within the next 3 to 4 days. Please note: If you use the Clearyl water cartridge and the display shows DECALCIFY / READY, then your cartridge function is not activated. Follow the instructions in chapter 16a to program the Clearyl Cartridge function.
Important: The decalcifying program must not be interrupted.
DECALCIFYING AGENT: Only use our special decalcifying tablets. For supplies see chapter 22.
CAUTION: Never use vinegar or any other decalcifying agent. This might damage internal parts of the machine.
1.Push the Rinse button. The display shows EMPTY TRAY.
2.Remove and empty the drawer and used coffee container and replace complete assembly (Fig. 21).
Important: Even if the drawer and the used coffee container are empty, you still need to remove the tray for approx. 20 seconds and then replace it. The display shows SOLVENT IN TANK / OPEN TAP.
3.Make sure the water tank is empty. Completely dissolve three of the white square tablets in 16 oz. of water and pour this mixture into the water tank.
4.Replace water tank. Place a large container (at least 20 oz.) underneath the frother.
21.
