JVC AV-27115, C-13110 manual Channel Summary Lock, Set Lock Code, Channel Guard Message

14 Initial Setup

Channel Summary - Lock

Press the MENU button

To CHANNEL SUMMARY

To operate

To the Lock Column

Zero to lock or unlock that channel

CH	ADD		:	CH	ADD
01	X	–	:	06	X	–
02	X	–	:	07	–
03	X	–	:	08	–
04	X	–	:	09	X	–
05	X	–	:	10	X	–

Exit when finished

Channel Guard Message

When a viewer attempts to watch a guarded channel, the following message appears:

THIS CHANNEL IS LOCKED BY CHANNEL GUARD.

PLEASE ENTER LOCK CODE BY 10 KEY PAD TO UNLOCK IT.

NO. - - - -

To watch a channel that you have locked, enter the Lock Code using the 10 key pad (see “Set Lock Code” - at the top of the next column).

If the wrong code is entered, this message will flash on the screen:

INVALID LOCK CODE !

The channel cannot be accessed until the correct code is entered.

•Once a channel has been unlocked, it will remain unlocked until the television is turned off.

Set Lock Code

(V-Chip, which appears before Set Lock Code in the onscreen menu system, is discussed in the four-page section beginning on page 15).

Channel Guard and V-Chip settings are protected by a four-digit Lock Code. Your TV comes pre-set with a Lock Code of "0000". You may change the code to any four-digit number you wish. To change the Lock Code, follow the steps below.

Press the MENU button

To SET LOCK CODE

To operate

The padlock icon appears

Press ZERO to access the Lock Code

LOCK CODE	0 0 0 0
	FINISH

The first digit will be highlighted

To select the number

To move to the next digit

Continue to follow these directions for all four

numbers

To FINISH

To save your settings and exit

THANK YOU !!

NOTES:

After a power interruption you must reset the Lock Code.

Write your Lock Code number down and keep it hidden from potential viewers.

If you forget the Lock Code, a new code may be set using the steps listed above.