JVC specifications Setting up your TV, Turn off the equipment including the TV before connecting

Setting up your TV

CAUTION

• Turn off the equipment including the TV before connecting.

1 Connecting the aerial cable.

VHF/UHF outdoor aerial

75-ohm coaxial cable (not supplied)

If you connect a VCR, connect the aerial output jack of your VCR and the aerial jack on the TV with aerial cable. Then connect the output jacks of your VCR and the VIDEO-1 input jacks of the TV with the video cable (or S-VIDEO cable if available) and audio cables. For details, see the manual of your VCR.

Rear of TV		VHF/UHF outdoor aerial
AV-2156BE
VIDEO-1	COMPONENT
		(VIDEO-2)	OUTPUT
INPUT
		INPUT
S
OVER
V	Y/V		V
L/MONO CB		L/MONO	L
R	CR	R	R

VCR

The illustration shown is just a sample. It may not be same as your TV.

2Connecting the main plug to the AC outlet.

3Inserting batteries into the remote control.

Insert two batteries by following the + and - polarities and inserting the - end first.

CAUTION:

Follow the cautions printed on the batteries. Notes:

• Use AA/R6/UM-3 dry cell batteries.

• If the remote control does not work properly, fit new batteries. The supplied batteries are for testing,

not regular use.

4Turn on the TV by pressing the main power button. JVC logo appears on the screen.

JVC logo will appear on the screen again at the phase of “SETUP TOUR RESTART?” function. Then the initial setting can be performed according to page 8.

Note:

While in the INSTALL menu with the cursor pointing at INSTALL, pressing the blue button will also display the JVC logo.

7