Connections
1) Plug one end of the AVCompu Link Cable into the AV Compu Link Input on your VCR,
DVD, or other Compu Link device.
2) Plug the other end of the AV Compu Link Cable into the AV Compu Link Input at the rear of
the TV.
NOTE:
• In order for the VCR playback to begin automatically, the recording tabs must be remove
from the VHS tape. If the tab is in place, automatic switching will occur when you push the
VCR’s Play button.
• The AVCompu Link cable has a male 3.5 mm (mono) plug on each end.
• If your JVC-brand VCR has “ACode/B Code Remote Control Switching” (see your VCR’s
instruction book), using VCR ACode will switch the TV to Input 1.
• To connect a JVCHiFi receiver or amplifier for a completely automated home theater, see
the HiFi’s connection instructions for detailed connection information.
• AVCOMPU LINK III is compatible with any AVCompu Link III receiver.
Connecting to JVC AV Compu Link III
JVC’s AVCompu Link feature makes playing video tapes or DVDs totally automatic. Simply
insert a pre-recorded tape into your JVC-brand VCR or DVD into your JVC DVD Player and
the device will automatically turn on and begin playback. At the same time, using the AV
Compu Link, the VCR or DVD player sends a signal to the television telling it to turn on and
switch to the proper video input.
• The AVCompu Link cable may be included with the JVC AV Compu Link accessory you
wish to connect. If it is not, contact an authorized JVC Service Center for
part # EWP 805-012.
• AVCompu Link can only be used with JVC-brand products.
18