English
Troubleshooting
Use this chart to help you solve daily operational problems. If there is any problem you cannot solve, contact your JVC service center.
PROBLEM | POSSIBLE CAUSE | SOLUTION | ||||
The display does not light up | The power cord is not plugged in | Plug the power cord into an AC outlet | ||||
| or the |
| POWER switch is | and press |
| POWER to set it in the |
|
|
| ||||
|
|
| ||||
| pressed to set in the ÑOFF position | _ON position | ||||
|
|
| ||||
No sound from speakers | Speaker signal cables are not | Check speaker wiring and | ||||
| connected | reconnect if necessary | ||||
|
|
|
|
| ||
| The SPEAKERS 1 and 2 are not | Press SPEAKERS 1 and 2 correctly | ||||
| set correctly |
|
|
| ||
|
|
| ||||
| An incorrect source is selected | Select the correct source | ||||
|
|
|
|
| ||
Sound from one speaker only | Speaker signal cables are not | Check speaker wiring and reconnect if | ||||
| connected properly | necessary | ||||
|
|
|
|
| ||
| The balance is set to one extreme | Adjust the balance properly (see page | ||||
|
|
|
| 12) |
|
|
|
|
| ||||
Howling during record | Your turntable is too close to | Move speakers away from the turntable | ||||
playing | speakers |
|
|
| ||
|
|
| ||||
Remote control does not | There is an obstruction in front of | Remove the obstruction | ||||
work | the remote sensor on the |
|
|
| ||
| amplifier |
|
|
| ||
|
|
| ||||
| Batteries are weak | Replace batteries | ||||
|
|
|
|
|
|
|
Page 27