JVC CA-MXDK11 Introduction, Precautions, Playable Disc Types, Installation, Power sources, Others

Introduction

Precautions

Installation

•Install the System in a location with adequate ventilation to prevent internal heat buildup in the System.

DO NOT install the System in a location near heat sources, or in a place subject to direct sunlight, excessive dust or vibration.

•Install in a place which is level, dry and neither too hot nor too cold—between 5°C and 35°C.

•Leave sufficient distance between the System and the TV.

•Keep the speakers away from the TV to avoid interference with the TV.

Power sources

•When unplugging the System from the wall outlet, always pull on the plug, not the AC power cord.

DO NOT handle the AC power cord with wet hands.

Moisture condensation

Moisture may condense on the lenses inside the System in the following cases:

•After starting to heat the room

•In a damp room

•If the System is brought directly from a cold to a warm place.

Should this occur, the System may malfunction. In this case, leave the System turned on for a few hours until the moisture evaporates, unplug the AC power cord, then plug it in again.

Internal heat

•Make sure there is good ventilation around the unit. Poor ventilation could overheat and damage the unit.

DO NOT block the ventilation openings or holes. If they are blocked by a newspaper or cloth, etc., the heat may not be able to get out.

Others

•Should any metallic object or liquid fall into the System, unplug the AC power cord and consult your dealer before operating any further.

DO NOT disassemble the System since there are no user serviceable parts inside.

•If you are not going to operate the System for an extended period of time, unplug the AC power cord from the wall

outlet.

If anything goes wrong, unplug the AC power cord and consult your dealer.

Playable Disc Types

DVD Logo is a trademark of DVD Format/Logo Licensing Corporation.

•CD-R/-RW/-ROM: Recorded in the Audio CD(CD-DA), Video CD and SVCD formats. MP3, WMA, JPEG, MPEG-1 and MPEG-2 files written in accordance with the “ISO 9660” format can also be played.

•DVD-R/-RW: Recorded in the DVD Video format or the DVD Video Recording (VR) format. MP3, WMA, JPEG, MPEG-1 and MPEG-2 files written in the UDF-Bridge format can also be played.

In addition to the above discs, this System can play back audio data recorded on CD Text, and CD-Extra.

•It is possible to play back finalized +R/+RW (DVD Video format only) discs. “DVD” lights on the front display panel when a +R/+RW disc is loaded.

•The following discs cannot be played back:

DVD-ROM, DVD-RAM, CD-I (CD-I Ready), CD-G (CD Graphics), Photo CD, etc.

Playing back these discs will generate noise and damage the speakers.

•This unit cannot play back DVD-VR discs with CPRM (Content Protection for Recordable Media).

•In this manual, “file” and “track” are interchangeably used for MP3/WMA/JPEG/MPEG-1/MPEG-2 operations.

About color system

This System accommodates both NTSC and PAL system and can play back discs recorded with either system.

To change the color system, see page 6.

Note on Region Code

DVD players and DVDs have their own Region Code numbers. This System can play back only DVDs with Region Code numbers including “4” for Australia and Central and South America, “3” for Southeast Asia, and “2” for the Middle East. For your available Region code, check the rear panel of your main unit.

EX.: For Southeast Asia

If a DVD with the improper Region Code numbers is loaded, “REGION ERR” appears on the display and playback will not start.

1