¤Voltage Selector
Use a screwdriver to rotate the voltage selector so that the voltage mark is pointing to the same voltage as where you are plugging in the unit. (See also the back cover page.)
When your mains lead (AC) | When your mains lead (AC) |
line voltage is | line voltage is 220 V |
Voltage mark | Voltage mark |
When your mains lead (AC) | When your mains lead (AC) |
line voltage is 110 V | line voltage is 127 V |
Voltage mark | Voltage mark |
DO NOT plug in before setting the voltage selector on the rear of the unit and all connection procedures are complete.
Preparing the Remote Control 
When using the remote control
Point the top of the remote control toward the remote sensor as directly as possible. If you operate it from a diagonal position, the operating range (approx. 5 m) may be shorter.
If the range or effectiveness of the remote control decreases, replace both batteries.
Caution
Do not expose batteries to heat or flame.
Changing the Color System 
You can select the video output to match the color system of your TV (PAL or NTSC).
1 Enter the color system setting mode.
(While holding...)
2 Select the color system.
3 Store the setting.
Canceling the Demonstration 
When you plug in the AC power cord to a wall outlet, the System automatically starts the display demonstration.
2 sec.
To start the demonstration, select DEMO START.
6
