JVC CA-MXDK11 manual Time Search, Chapter Search, A-BRepeat

A-B Repeat

1Select “A-B” in step 3 of “Repeat Play” on page 22.

2Select the start point (A).

•Before pressing ENTER/SET, you can search for the end point using y.

3Select the end point (B).

A-B Repeat starts. The selected portion plays repeatedly.

To cancel A-B Repeat, select “OFF” in step 1.

Time Search

You can move to a particular point by specifying the elapsed playing time from the beginning.

1While playing (without PBC for SVCD/VCD), display the on-screen bar with the pull-down menu.

•Time Search can be used before starting playback (not applicable for DVD Video).

2Select .

3Display the pop-up window.

4Enter the time.

You can specify the time in hours/minutes/seconds.

Examples:

To move to a point of 1 (hours): 02 (minutes): 00 (seconds), press 1, 0, 2, 0, then 0.

To move to a point of 54 (minutes): 00 (seconds), press 0, 5, 4, 0, then 0.

•It is always required to enter the hour digit (even “0” hour), but it is not required to enter trailing zeros (the last two digits in the examples above).

•To correct a misentry, press cursor to erase the last entry.

5Finish the setting.

The System starts playing from the specified time.

Chapter Search

You can search for the chapter number to play.

1While playing, display the on-screen bar with the pull-down menu.

2Select .

3Display the pop-up window.

4Enter the desired chapter number.

Examples:

To select number 5, press 5. To select number 10, press 1, then 0.

To select number 15, press 1, then 5.

To select number 30, press 3, then 0.

•To correct a misentry, press the number buttons until the desired number is shown in the pop-up window.

5Finish the setting.

The System starts playing the searched chapter.

23