JVC CA-MXG50 Getting Started

– 6 –

English

Getting Started

Unpacking

After unpacking, check to be sure that you have all the

following items.

The number in the parentheses indicates the quantity of the

pieces supplied.

• AM loop antenna (1)

• FM antenna (1)

• Remote control (1)

• Batteries (2)

• AC plug adaptor (1)

If any is missing, consult your dealer immediately.

Putting the Batteries into the Remote Control

Insert the batteries — UM-4/AAA/IEC R03 — into the

remote control, by matching the polarity (+ and –) on the

batteries with the + and – markings on the battery

compartment.

When the remote control can no longer operate the unit,

replace both batteries at the same time.

1

3

• DO NOT use an old battery together with a new one.

• DO NOT use different types of batteries together.

• DO NOT expose batteries to heat or flame.

• DO NOT leave the batteries in the battery

compartment when you are not going to use the

remote control for an extended period of time.

Otherwise, it will be damaged from battery leakage.

UM-4/AAA/IEC R03

Continued

2

Connecting Antennas

FM antenna

1Attach the FM antenna to the FM [75 Ω]

coaxial terminal.

2Extend the FM antenna.

3Fasten it up in the position which gives you

the best reception, then fix it on the wall, etc.

About the supplied FM antenna

The FM antenna supplied with this unit can be used as temporary

measure. If reception is poor, you can connect an outdoor FM

antenna.

To connect an outdoor FM antenna

Before connecting it, disconnect the supplied FM antenna.

FM antenna (supplied)

Outdoor FM antenna

(not supplied)

A 75 Ω antenna with coaxial type connector should be

used.

-

FM [75 ]

ANTENNA

AM

FM [75 ]

ANTENNA

AM

EN01-12.CA-MXG50[UW]_f 01.4.3, 2:16 PM6

Contents

Main COMPACT COMPONENT SYSTEM SISTEMAS DE COMPONENTES COMPACTOS SISTEMA DE COMPONENTE COMPACTO CA-MXG50[UW]COVER_f 01.4.3, 2:09 PM1 CA-MXG50 LVT0692-007A [UW] INSTRUCTIONS MANUAL DE INSTRUCCIONES INSTRUES Page G-2 Portugus Espaol G-3 IMPORTANT FOR LASER PRODUCTS / IMPORTANTE PARA PRODUCTOS LSER / IMPORTANTE PARA PRODUCTOS LASER G-4 REPRODUCTION OF LABELS / REPRODUCCIN DE ETIQUETAS / REPRODUO DE ETIQUETAS CLASS 1 LASER PRODUCT 1 Introduction About This Manual Precautions Installation Power sources Contents 3 Location of the Buttons and Controls Front Panel 4 Display Window 126 4 7 9p 35 q 8 Front Panel 5 Remote Control p e r Getting Started Unpacking Putting the Batteries into the Remote Control 3 Connecting Antennas 7 1 terminals on the rear of the unit. 2 into the terminal. 8 To connect audio equipment with an optical digital input terminal NOW, you can plug in the unit and other connected equipment FINALLY! Cancelling the Display Demonstration To start the display demonstration manually Common Operations Turning On or Off the Power Setting the Clock Press CLOCK/TIMER. Press 4 or to adjust the hour, then press SET. + + 11 Reinforcing the Bass Sound Selecting the Sound Modes 12 Listening to FM and AM Broadcasts Tuning in a Station Presetting Stations Tuning in a Preset Station 13 Playing Back CDs Loading CDs Press 0. Place one or two discs correctly on the front slots of the carrousel, with its label side up. If you wish to load a third disc, press DISC CHANGE on the unit or DISC SKIP on the remote control. 14 Basic CD Operations To exchange CDs during playback of another To skip to the another CD in the carrousel To stop play for a moment 15 Repeating Tracks or CDs Repeat Play Prohibiting Disc Ejection Tray Lock Program other tracks you want. Press CD 6. Playing Back Tapes Playing Back a Tape Press EJECT (0) for the deck you want to use. Put a cassette in with the exposed part of the tape down. Close the cassette holder gently. Recording Recording a Tape on Deck B Press EJECT 0 for the deck B. Put a recordable cassette in with the exposed part of the tape down. Close the cassette holder gently. 18 CD Synchronized Recording Dubbing Tapes 19 Using the Microphones Singing Along (Karaoke) Microphone Mixing 20 Using the Timers Using Daily Timer How Daily Timer actually works Press CLOCK/TIMER repeatedly until DAILY appears on the Press CLOCK/TIMER again. 21 When you have selected TUNER FM or TUNER AM in step 5. Select a preset station number. Press 4 or to set the volume level. Press SET to complete the Daily Timer setting. To turn on or off Daily Timer after its setting is done 22 Using Sleep Timer How Sleep Timer actually works On the remote control ONLY: Press SLEEP. Maintenance To get the best performance of the unit, keep your discs, tapes, and mechanism clean. Handling cassette tapes Handling discs Troubleshooting Specifications Amplifier section CA-MXG50 Tuner CD player Cassette deck V