JVC CA-MXG50 Listening to FM and AM Broadcasts, Tuning in a Station, Tuning in a Preset Station

Listening to FM and AM Broadcasts

English

Before operating the tuner, make sure you have selected the correct AM spacing intervals (see page 10).

Tuning in a Station

1 Press FM/AM.

The unit automatically turns on and tunes in the previously tuned station (either FM or AM).

•Each time you press the button, the band alternates between FM and AM.

2 Start searching for stations.
On the unit:
Press and hold TUNING + or	TUNING
TUNING – for more than 1
second.
On the remote control:
Press and hold 4or

¢for more than 1 second. The unit starts searching for stations and stops when a station of sufficient

signal strength is tuned in.

If a program is broadcast in stereo, the ST (stereo) indicator lights up.

To stop during searching, press TUNING + or TUNING – (or 4 or ¢on the remote control).

When you press TUNING + or TUNING – (or4or ¢on the remote control) briefly and repeatedly

The frequency changes step by step.

On the unit ONLY:

1 Tune in the station you want to preset.

• See “Tuning in a Station” on the left column.

2 Press SET. SET

3 Press PRESET + or PRESET – PRESET to select a preset number.

4 Press SET again. SET

The tuned station in step 1 is stored in the preset number selected in step 3.

•Storing a new station on a used number erases the previously stored one.

When you unplug the AC power cord or if a power failure occurs

The preset stations will be erased in a few days. If this happens, preset the stations again.

To change the FM reception mode
When an FM stereo broadcast is hard to receive or	FM MODE
noisy, press FM MODE on the remote control so that
“MONO” appears and the MONO indicator lights up on
the display. Reception improves.

To restore the stereo effect, press FM MODE again so that “STEREO” appears on the diplay and the MONO indicator goes off from the display.

Tuning in a Preset Station

1 Press FM/AM.

The unit automatically turns on and tunes in the previously tuned station (either FM or AM).

•Each time you press the button, the band alternates between FM and AM.

In this stereo mode, you can hear stereo sounds when a program is broadcast in stereo.

Presetting Stations

You can preset 30 FM and 15 AM stations.

In some cases, test frequencies have been already memorized for the tuner since the factory examined the tuner preset function before shipment. This is not a malfunction. You can

2 Select a preset number. On the unit:

Press PRESET + or PRESET –.

On the remote control:

Press the number buttons.

PRESET

1 2 3

preset the stations you want into memory by following the presetting method.

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

Ex.: For preset number 5, press 5.	4	5	6
For preset number 15, press +10	7	8	9
then 5.
For preset number 20, press +10,	10	+10

then 10.

For preset number 25, press +10, +10, then 5. For preset number 30, press +10, +10, then 10.

– 12 –