JVC CA-MXG51R Common Operations, Turning On or Off the Power, Setting the Clock, On the unit ONLY

Common Operations

Turning On or Off the Power

To turn on the unit, press

STANDBY

STANDBY/ON so that the STANDBY ECO

STANDBY/ON

lamp goes off.

2 Press 4or ¢to adjust the hour, then press SET.

PRESET

SET

To turn off the unit (on standby), press
STANDBY/ON again so that the	ECO
	STANDBY
STANDBY lamp lights up.	STANDBY/ON

A little power is always consumed even while the unit is on standby.

To switch off the power supply completely, unplug the AC

power cord from the AC outlet.

When you unplug the AC power cord or if a power failure occurs

The clock is reset to “– – : – –” soon, while the tuner preset stations (see page 11) will be erased in a few days.

Saving the Power Consumption While on Standby — ECO-mode

You can save the power consumption only while the unit is turned off (on standby).

To activate the ECO-mode, press ECO	STANDBY	ECO
while the unit is turned off (on standby).	STANDBY/ON
The display illumination (including the
display demonstration) disappears.

To deactivate the ECO-mode, press ECO again.

The display illumination appears.

About ECO-mode

While ECO-mode is activated, the display demonstration is canceled temporarily.

Setting the Clock

Before operating the unit any further, first set the clock built in this unit. You can set the clock whether the unit is on or off.

• If you want to correct the hour after pressing SET, press CANCEL. The hour digits start flashing again.

3 Press 4or ¢to adjust the	PRESET
minute, then press SET.

SET

To check the clock time

Press DISPLAY while playing any source.	DISPLAY
• Each time you press the button, the source
indication and the clock time alternate on the
display.

To adjust the clock again

If you have adjusted the clock before, you need to press CLOCK/TIMER repeatedly until “CLOCK” is selected.

•Each time you press the button, the clock/timer setting modes change as follows:

DAILY ON TIME REC

Canceled CLOCK ON TIME

If there is a power failure

The clock loses the setting and is reset to “– – : – –.” You need to set the clock again.

Selecting the Sources

To listen to the FM, MW or LW broadcasts, press FM/AM.

(See page 11.)

To play back CDs, press CD 6. (See pages 14 – 16.) To play back tapes, press TAPE 3. (See page 17.)

To select the external equipment as the source, press AUX.

On the unit ONLY:
1 Press CLOCK/TIMER.	CLOCK
	/ TIMER

The hour digits start flashing on the display.

When you press the play button for a particular source (AUX, FM/AM, CD 6, and TAPE 3), the unit turns on (and the unit starts playing the source if it is ready — COMPU PLAY CONTROL).

– 9 –