JVC CA-MXG51R manual Using Recording Timer, Press CLOCK/TIMER repeatedly, Press CLOCK/TIMER again

6 Select the preset station number. PRESET

Press 4 or ¢ to select the preset station number, then press SET.

The unit enters volume setting mode.

	SET
7 Press 4or ¢to set the volume
level.	PRESET
• You can select the volume level from
VOL MIN, VOL 1 — VOL 30, and
VOL MAX.

8 Press SET to complete the Daily	SET
Timer setting.

The DAILY (daily timer) indicator stops flashing and remains lit. The settings you have done are shown on the display in sequence for your confirmation.

9 Press	STANDBY/ON to	ECO
		STANDBY
turn off the unit (on standby)		STANDBY/ON
if you have set the Daily Timer
with the unit turned on.

If the unit is turned on when the timer-on time comes

Daily Timer does not work.

To turn on or off Daily Timer after its setting is done

1 Press CLOCK/TIMER repeatedly until	/ TIMER
	CLOCK
“DAILY” appears on the display.

2 To turn off the Daily Timer, press

CANCEL.CANCEL

/DEMO

The DAILY (daily timer) indicator goes off from the display (“OFF” appears for a while). The Daily Timer is canceled, but the setting for the Daily Timer remains in memory.

To turn on the Daily Timer, press SET. SET

The DAILY (daily timer) indicator lights up on the display. The settings you have done are shown on the display in sequence for your confirmation.

Using Recording Timer

With Recording Timer, you can make a tape of a radio broadcast automatically. You can set the timer whether the unit is on or off.

How Recording Timer actually works

The unit automatically turns on, tunes into the specified station, sets the volume level to “VOL MIN,” and starts

recording when the on-time comes (the indicator flashes while the timer is operating). Then, when the off-time comes, the unit automatically turns off (stands by).

The timer setting remains in memory until you change it.

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

•If you have made a mistake while setting the timer, press CANCEL. (However, this does not always work. If CANCEL does not work, press CLOCK/TIMER repeatedly and start from step 1 again.)

On the unit ONLY:

1 Put a recordable cassette into deck B.

2	Press CLOCK/TIMER repeatedly	CLOCK
		/ TIMER

until “REC” appears on the display.

indicator lights up and the REC

(recording timer) indicator also starts flashing on the display.

•Each time you press the button, the timer setting modes change as follows:

DAILY		ON TIME		REC
Canceled		CLOCK	ON TIME
	(See page 9.)

3 Press CLOCK/TIMER again.	/ TIMER
	CLOCK

“ON TIME” appears for 2 seconds, then the unit enters on-time setting mode.

– 21 –