Tuning in a Station
Press the FM/AM button (or the TUNER button on the Remote Control) to turn on the radio.
FM/AM | The Frequency of the previously selected channel appears on the display. |
|
Switching between Frequency Bands
Press the FM/AM button.
Each time you press the button, the band alternates between FM and AM.
Selecting a Radio Station —————————————————————
❏Select a frequency by adjusting the MULTI CONTROL stick up or down. The frequency
changes in one step increments. “TUNED” appears on the display when a signal is found. This is called Manual Tuning.
The frequency increases when MULTI CONTROL stick is pressed upwards, and decreases when the MULTI CONTROL stick is pressed downwards.
❏If the MULTI CONTROL stick is pressed up or down continuously for a few seconds, the frequency changes continuously until a signal is found, then “TUNED” appears on the display. This is called Auto Tuning.
❏ Possible only after presetting stations.
Using the Unit
Select a preset channel by adjusting the MULTI CONTROL stick left or right.
Using the Remote Control
TUNER | 1. Press the TUNER button so that you can receive the most recent station tuned in. |
| |
| 2. Select the station by entering the preset number in the number keys of the Remote Control. |
❏Example: for channel 5, press 5. For channel 15, press +10 then 5. For channel 20, press +10, then 10. For channel 32, press +10 three times, then 2.
Presetting Stations
English
1
FM/AM
2
3 | SET |
| / |
4
5
SET
/
You can store up to 40 of your favorite radio stations (FM and AM) in memory, giving you quick, easy access to the stations.
Note: In some cases, test frequencies have been already memorized for the tuner since the factory examined the tuner preset function before shipment. This is not a malfunction. You can preset the stations you want into memory by following the presetting method.
1.Select a frequency band by pressing the FM/AM button.
2.Tune to a station by adjusting the MULTI CONTROL stick up or down.
3.Press the SET/DEMO button.
On the display, “SET” will blink for 5 seconds.
❏During these 5 seconds while “SET” is blinking, you can assign a channel number to the station and enter it into the memory as follows.
4.Select a preset number by adjusting the MULTI CONTROL stick left or right.
5.Press the SET/DEMO button and the station will be assigned to the channel number showing on the display.
“MEMORY” appears in the display.
❏If a station has been previously stored using the same channel number, this will be erased and the newly selected station will be stored.
❏If “SET” in the display goes off, start again from step 3.
17