JVC CA-V888T manual Connecting the AM Antenna, English, Right speaker

CAUTION: Make all connections before plugging the Unit into an AC power outlet.

Connecting the AM Antenna

English

AM	GND
LOOP
	AM
	EXT

12

AM antenna wire (Not supplied) If reception is poor, connect the outside antenna.

Note: Even when connecting an outside AM antenna, keep the indoor AM loop connected.

	AM Loop Antenna
3	Turn the loop until you
	have the best reception.	Snap the tabs on the loop
		into the slots of the base to
		attach the AM Loop.

Connecting the Speakers (Please refer to instructions for speakers as will when you connect speakers.)

For each speaker, connect one end of the speaker wire to the speaker terminals on the back of the CA-V888T and the other end to the speaker.

1.Open each of the terminals and insert the speaker wires firmly (be sure to remove the insulation at the end of each wire first), then close the terminals.

2.Connect the red (+) and black (–) terminals of the right side speaker to the red (+) and black (–) terminals marked RIGHT on the CA-V888T.

Connect the red (+) and black (–) terminals of the left side speaker to the red (+) and black (–) terminals marked LEFT on the CA-V888T.

SPEAKERS
RIGHT	LEFT
+	+
–	–

Right speaker Left speaker

1 2 3

IMPORTANT: Use speakers with the correct impedance only. The correct impedance is indicated on the back panel.

CAUTION: If a TV is installed near speakers, the TV may display irregular colors. In this case, set the speakers away from the TV.

5