Manuals / Brands / Home Audio / Stereo System / JVC / Home Audio / Stereo System

JVC CA-VSDT2000, SP-PW2000, SP-VSDT2000 Troubleshooting

1 32

Download 32 pages, 1.86 Mb

26

Troubleshooting

•If you are having a problem with your System, check this

list for a possible solution before calling for service.

•If you cannot solve the problem from the hints given

here, or the System has been physically damaged, call a

qualified person, such as your dealer, for service.

Symptom Possible Cause Action

No sound is heard. •Connections are incorrect, or loose.

•Headphones are connected.

•Check all connections and make

corrections. (See pages 4 to 8.)

•Disconnect the headphones.

Poor radio reception •The antenna is disconnected.

•The AM Loop Antenna is too close to the

System.

•The FM Wire Antenna is not properly

extended and positioned.

•Reconnect the antenna securely.

•Change the position and direction of the

AM Loop Antenna.

•Extend FM Wire Antenna to the best

reception position.

The CD skips. The CD is dirty or scratched. Clean or replace the CD.

The CD does not play. The CD is upside down. Put the CD in with the label side up.

Unable to operate the Remote Control. •The path between the Remote Control

and the sensor on the Unit is blocked.

•The batteries have lost their charge.

•Remove the obstruction.

•Replace the batteries.

Operations are disabled. The built-in microprocessor has

malfunctioned due to external electrical

interference.

Unplug the System then plug it back in.

“CD NO DISC” appears.

There is no disc loaded.

Insert a disc.

“CANNOT PLAY” or

“UNFINALIZ”

appears.

•The CD-R or CD-RW that hasn’t yet been

finalized (including blank discs) has been

inserted.

•The disc has been inserted with its label

side down.

•Insert a CD-R or CD-RW that has been

finalized.

•Remove the disc and insert it with the

label side front or up. (See page 18.)

The characters and symbols on the display

appear upside down.

The DISP.SET switch on the rear panel of

the Center Unit has not been set correctly.

Set the DISP.SET switch correctly. (See

page10.)

Subwoofer automatically turns on, but no

sound is output.

The volume knob of the Subwoofer is set to

MIN position.

Adjust the volume knob.

Subwoofer does not automatically turn on. The volume knob of the Subwoofer is set to

MIN position. Also, the volume level of the

Center Unit is low.

Adjust both volume levels.

VS-DT2000(J)_EN.book Page 26 Wednesday, February 6, 2002 4:37 PM

Contents

Main COMPACT COMPONENT SYSTEM VS-DT2000(J)_EN.book Page 1 Wednesday, February 6, 2002 4:37 PM For Customer Use: VS-DT2000 SP-PW2000SP-VSDT2000CA-VSDT2000SP-VSDT2000 Consists of CA-VSDT2000, SP-VSDT2000 and SP-PW2000 G-1 Warnings, Cautions and Others / Mises en garde, prcautions et indications diverses (For U.S.A) INFORMATION G-2 For Canada/pour le Canada For Canada/pour Le Canada CAUTION ATTENTION Introduction Features How This Manual Is Organized WARNINGS IMPORTANT CAUTIONS Table of Contents Getting Started Accessories How To Put Batteries In the Remote Control Handle batteries properly. Make all connections before plugging the System into an AC power outlet. Connecting the FM Antenna Rear Panel of the Center Unit (CA-VSDT2000) Using the Supplied Wire Antenna Using the Coaxial Type Connector (Not Supplied) A 75 antenna with coaxial type connector should be con- nected to the FM 75 COAXIAL terminal. If reception is poor, connect the outdoor antenna. Connecting the AM Antenna Rear Panel of the Center Unit (CA-VSDT2000) VS-DT2000(J)_EN.book Page 5 Wednesday, February 6, 2002 4:37 PM AC IN Screw (not supplied) Turn the loop until you have the best reception. Connecting the Speakers (SP-VSDT2000) Warning Attaching the Spacers Connecting the Powered Subwoofer (SP-PW2000) Connecting External Equipment Connecting an MD Recorder, etc (Digital Output) Connecting the AC Power Cord Installing the Unit on the Stand Installing the Equipment on the Wall Attachment to a wall Location of attachment to a wall Example of attachment (Center Unit) Example of attachment (Speakers) Set the DISP.SET switch to H. Set the DISP.SET switch to V. Changing the Display and Control Buttons Settings When the Unit is placed vertically Using the Remote Control COMPU Play On the Remote Control On the Unit Basic Operations Turning the Power On and Off Turning the System On Turning the System Off Adjusting the Brightness (DIMMER) When the System is Turned On 1 tem. 2 Control. 3 1 on the Remote Control. 2 on the Remote Control to adjust the bass level. TREBLE Control 1 on the Remote Control. 2 on the Remote Control to adjust the treble level. Showing the Time (DISPLAY) Using the Powered Subwoofer Operating the Powered Subwoofer Presetting the Volume 1 woofer to turn on the power. 2 INPUT Terminals INPUT(LOW-LEVEL): When the Center Unit CA-VSDT2000 is not used (Using other equipment) INPUT (HIGH-LEVEL): Using the Tuner One Touch Radio Tuning In a Station 1 2 1 2 tune in a station. 3 4 Using the CD Player To Insert a CD 1 2 label side front or up as shown below. 1 2 To Select a Track or Passage within a Track Search Play Programming the Playing Order of the Tracks 1 2 3 4 5 track to program. 6 for the program. 7 Using External Equipment Listening to External Equipment 1 2 Recording the Systems Source to External Equipment Using the Timers Setting the Clock 1 2 Remote Control. 3 1 2 3 4 5 6 the music source selected in step 3. 7 tem. Setting the SLEEP Timer Care And Maintenance Compact Discs General Notes Cleaning the unit Moisture Condensation Troubleshooting Page Page Specifications 325 mm 105.5 mm 140 mm 237 mm