JVC DLA-HX2U, DLA-HX2E manual Installing the Projector against the Screen, Mounting the Projector

Installing the Projector

Installing the Projector against the Screen

The picture quality may deteriorate when performing KEYSTONE compensation. It is recommended to place the projector perpen- dicularly to the screen.

 Side View  Top View

•Trapezoidal-distortion can be corrected using the [KEYSTONE]* buttons on the projector. (☞ page 30)

Up to approximately 30° upward and downward from the horizontal line.

Up to approximately 10° upward and downward from the vertical line.

*If the KEYSTONE compensation is used simultaneously for upper/lower/left/right directions, the compensating range will decrease.

Mounting the Projector

When mounting of the projector is required, do it using the embedded three screw holes (M6 nuts) at the bottom of the projector.

Precaution for ceiling-mount

• To ceiling-mount and adjust the projector, special exper- tise and techniques are necessary. Be sure to ask your dealer or specialist to perform the work.

• Do not mount on places that will be subjected to knocks and vibrations.

• As the depth of the screw holes is 10 mm, use screws shorter than 10 mm but longer than 6 mm. Otherwise, the screws will damage the internal parts of the projector caus- ing malfunction.

• Install at a safe place in case this unit or a part of it may drop. If the light-source lamp is broken, small pieces of glass from the mesh of the filter may appear outside this unit.

16