Troubleshooting
Symptom | Probable cause | Corrective action | Page |
|
|
|
|
Video image is fuzzy. | Is the focus adjusted correctly? | • Adjust focus with the focus ring of the lens. | 26 |
|
|
|
|
| Is the projector placed too near or too far from | • Set the projector at the correct distance. | 17 |
| the screen? |
|
|
|
|
|
|
| Are “Tracking” and “Phase” adjusted correctly? | • Adjust “Tracking” and “Phase” using the menu. | 37 |
|
|
|
|
Video image is ab- | Is the “Brightness” adjusted correctly? | • Adjust “Brightness” using the menu. | 37 |
normally dark or |
|
|
|
bright. |
|
|
|
|
|
|
|
Color is poor or un- | Is the picture quality (color density, etc.) ad- | • Adjust picture quality using the menu. | 37 |
stable. | justed correctly? |
|
|
|
|
|
|
| Is the correct “Decoder” selected? | • Set the “Decoder” to “AUTO” or the correct | 38 |
|
| dedicated decoder. |
|
|
| • If the problem is not rectified after setting to |
|
|
| “AUTO”, set to forced dedicated mode. |
|
|
|
|
|
| Are signals (scanning frequency, etc.) from the | • Check if the signal is appropriate (scanning | 19, 20 |
| connected device appropriate? | frequency, etc.), and input the appropriate sig- |
|
|
| nal. |
|
|
|
|
|
| Is the [PC2] input terminal being used? | • When the [PC2] input terminal is being used, | 39 |
|
| “PC2(BNC)” must be selected from the |
|
|
| “Options” menu. Set it correctly according to |
|
|
| the input signal. |
|
|
|
|
|
The upper part of the | If the input signal comes from a computer sys- | • Input separate sync signals for vertical sync | 19, 20 |
video image bows or | tem, is this a sync signal of composite sync (Cs) | (V) and horizontal sync (H) signals. |
|
distorts. | or G on sync type? |
|
|
|
|
|
|
| Are signals with much jitter or skew distortion | • Input signals with little jitter or skew distor- | |
| being input from a video deck? | tion. |
|
|
| • Use a TBC or a device with a |
|
|
|
|
|
Remote control unit | Are batteries installed correctly? | • Match the polarities of batteries correctly, as | 14 |
does not work. |
| shown on the battery cartridge. |
|
|
|
|
|
| Are batteries exhausted? | • Replace with new batteries. | 14 |
|
|
|
|
| Is there an obstructive object between the re- | • Remove any shielding objects. | 18 |
| mote control unit and the remote sensor? |
|
|
|
|
|
|
| Is the remote control held too far from the sen- | • Use the remote control unit at a nearer point. | 18 |
| sor? |
|
|
|
|
|
|
•This projector uses a micro computer. External noise may cause it to malfunction. If this happens, unplug from the main power outlet and then plug on again. (☞ page 25, 27)
52
