Menu Configuration—MAIN MENU

For the operation procedure, see page 7.

DT-V24G11Z

Operation guide

Shows the buttons for each operation.

DT-V20L3GZ

Operation guide

Shows the buttons for each operation.

12

PICTURE FUNCTION

Setting for the picture quality

Item

To do

Setting value

APERTURE*1

Activates/deactivates the function at the level set in

OFF, ON

(For DT-V24G11Z)

“APERTURE LEVEL.”

 

APERTURE FREQ.*1

Select the frequency of the luminance signal compensated in

OFF, LOW, HIGH

(For DT-V20L3GZ)

“APERTURE LEVEL.”

 

APERTURE

Compensate the frequency response of the luminance signal of

01 – 10

LEVEL*1

the video signal.

 

CTI

Adjust the clearness of the outlines of the chrominance signal.

OFF, NORMAL,

 

 

HARD

LTI

Adjust the clearness of the outlines of the luminance signal.

OFF, NORMAL,

 

 

HARD

I/P MODE

Selects a proper mode corresponding to the input picture.

NORMAL, CINEMA,

 

 

FIELD

sub menu

Display the sub menu which enables you to adjust the items of “PICTURE FUNCTION”

 

while viewing the actual picture.

 

reset

Restore the default settings for all the items in “PICTURE FUNCTION.”

*1 Memorized for each input.

BACK LIGHT Setting value: –20 – +20

Adjusts the brightness of the display.

• Adjust according to the ambient light conditions.

3G SDI LEVEL B Setting value: DS1, DS2

Selects the data stream from two HD SDI signals multiplexed when a 3G SDI level B signal comes in.

SDI DUAL LINK Setting value: OFF, ON

Activates/deactivates the DUAL LINK function of SDI signals.

•“DUAL LINK” is displayed when the setting is set to “ON.” No other status indications of SDI signals are displayed.

•Set this setting to “OFF” when an SDI signal other than DUAL LINK SDI is input.

COMPO./RGB SEL. Setting value: COMPO. (COMPONENT), RGB

•The menu automatically disappears in about 30 seconds after the previous operation.

•Some items may not appear on the menu depending on the input or the input signal.

•The items controlled by the MAKE system do not appear on the menu.

Selects the signal type you want to use for COMPO./RGB terminals.