Daily Operations / Connections (cont.) | 8 |
7Rear panel
1 2
Security slot
Attach a security wire to this slot.
The illustration of the monitor is of
1POWER switch
Turns AC power on or off.
• You need to press 
button (☞ u on page 6) to use the monitor after turning on the POWER switch.
2AC IN terminal
AC power input connector.
Connect the provided AC power cord to an AC outlet.
•Attach the provided power cord holder to prevent accidental disconnection of the AC power cord (☞ “Attaching the power cord holder” on page 9).
CAUTION
Do not connect the power cord until all other connections are completed.
3REMOTE terminal
Terminal for controlling the monitor by an external control (☞ “External Control” on page 21).
4VIDEO (INPUT 1/INPUT 2) terminals (BNC)
Input (IN) and output (OUT) terminals for the composite signals.
5COMPO./RGB (G/Y,
Input (IN) and output (OUT) terminals for the analog component (color difference) or analog RGB signals.
• Select the signal type in “COMPO./RGB SEL.” corresponding to the type of the input signal (☞ page 12).
6EXT.SYNC (CS) terminals (BNC)
Input (IN) and output (OUT) terminals for the external composite sync (Cs) signals.
•To use these terminals, set “SYNC INPUT SEL.” to “EXT.” (☞ “SYNC FUNCTION” on page 15).
•The terminals are for all VIDEO (INPUT 1, INPUT 2) and COMPO./RGB.
•When an external sync signal is input, external synchronization has priority over all VIDEO 1, VIDEO 2 and COMPO./RGB input.
7AUDIO ASSIGN (IN 1/IN 2) terminals (pin jack) Input terminals for the analog audio signals.
•Use this terminal for the analog audio connection of the SDI. When a superimposed signal (EMBEDDED AUDIO signal on an SDI signal) is input, analog audio signals cannot be input.
•Select the video input to assign the audio signal in “AUDIO1 ASSIGN.” or “AUDIO2 ASSIGN.” (☞ “AUDIO SETTING” on page 14).